Setting operant devices
| < PREVIOUS: Setting playbacks | > NEXT: Live Sound Analysis |
|
|
|
|
|
|
|
Assuming you already installed a digital I/O National Instruments card and set up the keys as documented in the installation chapter, here you set SAP2011 to recognize those keys. In the Operant device tab, check 'enabled operant training' and you should see this display:
 Device ID: Usually set to 1, unless you have more than one NI card in your computer.
Ports: Number of digital I/O ports in your card (usually at least 3).
For each key, you need to set a port number and a line number.
|
|